For “how should the temperature and time of the baking match” control stability, a distinction is first to be made between the intrinsic properties of the material, its state and the thermomechanical effects of the equipment. The key mechanism for this theme is that dry temperatures determine the rate of water dispersion and time determines the extent to which the target water content is achieved within the particles. Hydrological management encompasses drying capacity, spot, layer, transport and back-tide control, and the endpoint is the effective determination. Therefore, the name of the material and the recommended setting can only be used as a starting point, and the actual judgement is to return to the plate number, water, filling and assistor, the single total quantity, cycle, screw structure and product requirements to confirm whether the temperature, cut and stay of the material in the equipment is safe.

At the test-model or volume-import phase, an input list should be established around “how to match the temperature and timing of the baking” and should include feedstock suppliers and batches, technical data sheets, dry conditions, the ratio of color mothers and retrofits, specifications for equipment and screws, product and flow weights, the temperature of the moulds and existing defects. If cross-platform reproduction is required, the screw surface velocity, unit gel volume and time of stay shall be converted and the speed and temperature shall not be applied directly. The main risks of the subject are: excessive temperature that causes blocking, oxidation or pre-crystal abnormalities, and lack of time when water from the core is not released. Parameters must be recorded in a specific pattern to distinguish material from equipment from operational changes.

Control methods should not begin with blindly increasing temperature or pressure, but should be based on "substance state - feed drying" The sequence of screw plasticization - nozzles and fluids - product results. Anomalous analysis begins with a determination as to whether it occurs suddenly or slowly: the former is mostly related to pollution, carcasses or changes, while the latter often points to wear, retour and batch trends. The site adjusts only one main variable at a time, while observing the actual melting temperature, measuring time, screw twists, mats, injection pressure, product weight, colour, scent and critical dimensions. If production can only be sustained by extreme parameters, the use of a switch to cover the material or hardware boundary should be discontinued.

The validation of “how to match the temperature and time of the baking” suggests a repeatable method: a time gradient sample to detect water content, particle state and formation mass. For custom screws or surface programmes, the smelting temperature level, twirling, capacity, fibre retention and full life cost should be verified simultaneously. The technical agreement between the supplier and the plant shall state the material, the sampling method, the detection project, the permitted scope and the change notification requirements. The plasticization programme can only be considered to have long-term quantitative value if the product ' s probabilities, performance, cyclicality, energy consumption and maintenance costs are met in a continuous production process.