In the material selection and on-site modems, “how does the scenic fluctuations of the product relate to plasticization and stability” not only depend on the supplier's temperature table, but also combines real product validation. The key mechanisms of this theme are: Melting temperature, dispersion, water content and measurement of duplication will change surface reproduction and lightness. Appearance defects are often caused by a combination of moisture, gas, materials, plasticization, moulds and equipment, and must be distinguished by evidence. Therefore, the name of the material and the recommended setting can only be used as a starting point, and the actual judgement is to return to the plate number, water, filling and assistor, the single total quantity, cycle, screw structure and product requirements to confirm whether the temperature, cut and stay of the material in the equipment is safe.

At the test-model or volume-import stage, an input list should be established around “what is the relationship between luminous fluctuations in products and plastic stabilization”, including feedstock suppliers and batches, technical data sheets, dry conditions, colour mothers and retrofit ratios, equipment and screw specifications, product and fluid weights, the temperature of the moulds and existing defects. The field can start with a low-risk median and change only one main variable at a time in the heat balance and keep at least a few of the constant data continuously. The main risks of this theme are that adjustments to the temperature of the modulus only ignore material batches, back pressure, colored mother and melting temperature differentials. Parameters must be recorded in a specific pattern to distinguish material from equipment from operational changes.

Control methods should not begin with blindly increasing temperature or pressure, but should be based on "substance state - feed drying" The sequence of screw plasticization - nozzles and fluids - product results. The refuelling, shutdown and clean-up are part of the plasticization process and should be standardized and versioned with normal production parameters. The site adjusts only one main variable at a time, while observing the actual melting temperature, measuring time, screw twists, mats, injection pressure, product weight, colour, scent and critical dimensions. If production can only be sustained by extreme parameters, the use of a switch to cover the material or hardware boundary should be discontinued.

Validation of the “relevance of scenic fluctuations and plastic stabilization of products” suggests a replicable method: synchronized recording of light, melting temperature, measuring time, colour differentials, and temperature and pressure. In case of over-limits, the relevant batches and products should be isolated before re-entry, downgrade or stoppage is decided on the basis of retention and trend data. The technical agreement between the supplier and the plant shall state the material, the sampling method, the detection project, the permitted scope and the change notification requirements. The plasticization programme can only be considered to have long-term quantitative value if the product ' s probabilities, performance, cyclicality, energy consumption and maintenance costs are met in a continuous production process.