The cause of the unmelted particles and the uneven plastic spiral
For end-of-pipe aggregation plants, review the causes of unmelted particles and the uneven plasticization of the screws, combining product, raw material, platform, production, life…
SELECTION GUIDE FOR INJECTION MOLDING FACTORIES
Selection Guide for Injection Molding Factories
Helps injection molding factories select custom screws based on equipment, resin, product, output, yield and maintenance cost.
Improved product fibre-fibre and rough-surface screw selection
In the case of end-of-pipe plating plants, there is an improvement in the choice of fibre-optic fibres and surface rough screws, combining products, raw materials, platforms, produ…
How to avoid overcuting when the product is fractured and its strength falls
For end-of-pipe retrofitting plants, talk about how to avoid overcuting when the fissure and intensity of the product fall, combining product, raw material, platform, production, l…
Spiral selection and verification when entropy temperature is excessive
(c) For end-of-pipe aggregation plants, to reduce the cost of scrap, shutdown and full life cycle by demancipating and certifying the screw type when the temperature of entropy is…
How to check screw measurement stability when size drifts
For end-of-pipe aggregation plants, talk about how to check the measuring stability of screws when size drifts, combining product, raw material, platform, production, life cycle an…
How to distinguish between molds, processes and the cause of the reversal of the ring under the question of flying edges
For end-of-pipe aggregation plants, explain how to distinguish between molds, processes and the cause of the reversal of the ring under the flyside problem, combining product, feed…
Is there a need to replace the screws with a lack of material and a lack of filling?
For end-of-pipe retrofitting plants, it is explained whether missing materials and impurities need to be replaced with screws that combine product, feedstock, platform, production,…
The logic of the screws in silver silk, bubbles and water.
(b) For end-of-pipe retrofitting plants, to explain the logic of screw selection under silver wire, bubbles and water plumes, combining product, raw material, platform, production,…
Note plastic stripes and mixed and uneven screw improvement
For terminal retrofitting plants, a screw improvement programme that addresses the unevenness of plastics and mixes, combines product, raw material, platform, production, life cycl…
How to judge when products are frequently black dots is a screw-up problem.
In the case of end-of-pipe retrofitting plants, it is clear how the product is judged to be a screw-selection when the black spot is frequent, combining product, raw material, plat…
100 posts · Page 7 of 10
SCREW & BARREL PRODUCTS
Injection molding screw product rolling display
According to the resin material, filling ratio, equipment model and product requirements, select a more suitable screw and barrel solution.