The determination of how to reduce the dead end and the black point of the cap of transparent material begins with the placement of structural dimensions, material behaviour and actual production loads in the same logical chain. At its core is transparency material that is very sensitive to trace focus and chromosomal, which requires a continuous, smooth and easily self-cleaning wheel. Retention areas may be formed by the turn of the channel, the root of the screw, the back of the proxies and the gap between them. The screwhead and the reversible ring are at the front end of high pressure, high temperature and fast-forward, and their mobility, sealing, strength and cleanness must be met simultaneously. A usable manufacturing map is not only a common name, but also a signal, a measuring transect, a surface state and a receiving and inspection belt to accompany the drum. Nominal specifications are therefore only the starting point, and the final conclusions must serve the actual resin, product and volume rhythm.

When customizing around the "how to reduce the dead end and black point of the transparency screw " , first collects the size of the equipment model, the original screw and the material drum, the driving power, the resin plate number and the filling system, the single mass, the cycle and existing defects. The specific selection principle for this topic is that the design should reduce sharp angles and closed dents and increase the polishing and corrosive resistance of surfaces in contact with the melt. If the device can export a curve, the original record of screw position, turn speed, twist, back pressure and time should be kept, so as to avoid only being assessed by the operator. The technical agreement should include quantifiable provisions for size benchmarks, key communications, material status and acceptance methods so that new, old and subsequent restorations can be compared under the same criteria.

The most important defence against the failure of the subject is that the materials in the dead corner experience multiple thermal cycles and become carbonized, and when the refuelling or pressure fluctuates, they fall off to form black spots. A curved envelope of the normal package should be created to see if the abnormal cycle occurs at the feed, later-storage, injection start or voltage stage. For on-site processing, only one main variable is changed each time and the measurement time, twist, melting temperature, mat, injection pressure and product weight are aligned to the same pattern. If production is to be sustained by excessive temperature, turn speed or back pressure, the use of parameters to mask structures, wear or collage should be discontinued.

This replicable approach can be used to verify how “transparent screwheads can reduce dead end and black dots”: a colour conversion test using light or transparent cleans, counting black dots and tracking the location of residues during dismantling. The results of the validation should be the denominator of the eligible products, while counting the time spent on energy consumption, cleaning, stoppage and maintenance, which is closer to real value than a separate comparison of the purchase price. Inquiries to suppliers should also be accompanied by information on resins and fillings, risk of flame retardation or corrosion, total weight of products and fluids, photographs of available screws and equipment curves. The programme is considered to have a stable engineering value when the detection data, the good product rate, the timing of the switch and the unit cost of the eligible goods are improved.